REAR LOWER ARM INSTALLATION

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH


    1. A01EQHI

      Temporarily install the lower control arm and 2 washers with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION


    1. Install the rear wheels.

      Torque:
      131 N*m  { 1336 kgf*cm, 97 ft.*lbf }

    2. Lower the vehicle.

    3. Press down on the vehicle several times to stabilize the suspension.

  3. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    1. Tighten the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Perform this procedure with all 4 wheels on the ground.