FRONT STABILIZER BAR INSPECTION


  1. INSPECT FRONT STABILIZER LINK ASSEMBLY LH


    1. A01ENY2

      Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

    2. Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

      Torque:
      Standard turning torque
      0.5 to 3.4 N*m  { 5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf }

      If the value is not within the specified range, replace the front suspension toe control link with a new one.

    3. Check the dust boot for cracks or grease leakage.