ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. A00JTVWE02

      Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free from foreign matter.

    2. Using SST, tap in the oil seal until its surface is flush with the engine rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note

      Wipe off any extra grease on the crankshaft.

  2. INSTALL FLYWHEEL HOUSING DUST SEAL

  3. INSTALL REAR END PLATE


    1. Install the rear end plate with the 2 bolts.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf }

  4. INSTALL FLYWHEEL SUB-ASSEMBLY

    A00OAALE01

    1. Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021

    2. Clean the bolts and bolt holes.

    3. Apply adhesive to 2 or 3 threads of each of the bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    4. Install the flywheel to the crankshaft.

    5. Temporarily install the flywheel with the 8 bolts.

    6. A00O3ZIE01

      Tighten the 8 bolts uniformly in several steps in the order shown in the illustration.

      Torque:
      123 N*m  { 1249 kgf*cm, 90 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing.

  5. INSTALL CLUTCH DISC ASSEMBLY


    1. A00JW1TE01

      Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel to install the clutch disc.

      SST
      09301-00110
      Text in Illustration
      A00JWY4 Flywheel Side

      Note

      Be sure to install the clutch disc so that it is facing in the correct direction.

  6. INSTALL CLUTCH COVER ASSEMBLY

    A00JUITE02
    Text in Illustration
    *a Matchmark

    1. Align the matchmarks on the clutch cover and flywheel.

    2. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

      SST
      09301-00110
      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

      Tech Tips

      Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.

  7. INSTALL MANUAL TRANSMISSION ASSEMBLY


    1. Install the manual transmission Click here.