TURN SIGNAL FLASHER ASSEMBLY INSPECTION


  1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    1. A01CC6NE14

      Disconnect the G29 turn signal flasher assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G29-1 (IG) - Body ground Engine switch off Below 1 V
      Engine switch on (IG) 11 to 14 V
      G29-4 (B) - Body ground Always 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      G29-5 (EL) - Body ground Turn signal switch off 10 kΩ or higher
      Turn signal switch in LH position Below 1 Ω
      G29-6 (ER) - Body ground Turn signal switch off 10 kΩ or higher
      Turn signal switch in RH position Below 1 Ω
      G29-7 (E) - Body ground Always Below 1 Ω
      G29-8 (HAZ) - Body ground Hazard warning switch off 10 kΩ or higher
      Hazard warning switch on Below 1 Ω

      If the result is not as specified, repair or replace the wire harness or connector.

    4. A01CC41E07

      Reconnect the G29 turn signal flasher assembly connector.

    5. Measure the voltage according to the valve(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      G29-2 (LR) - Body ground Hazard warning switch off Below 1 V
      Hazard warning switch on 11 to 14 V (60 to 120 times per minute)
      Turn signal switch off Below 1 V
      Engine switch on (IG) and turn signal switch in RH position 11 to 14 V (60 to 120 times per minute)
      G29-3 (LL) - Body ground Hazard warning switch off Below 1 V
      Hazard warning switch on 11 to 14 V (60 to 120 times per minute)
      Turn signal switch off Below 1 V
      Engine switch on (IG) and turn signal switch in LH position 11 to 14 V (60 to 120 times per minute)

      If the result is not as specified, replace the turn signal flasher assembly.