TURN SIGNAL FLASHER ASSEMBLY REMOVAL


  1. REMOVE COWL SIDE TRIM BOARD RH (for RHD)


    1. A01CFL6

      Remove the clip.

    2. Disengage the clip, claw and 2 guides, and remove the cowl side trim board RH.

  2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)


    1. A01CFFK

      Remove the 2 screws <B>.

    2. Disengage the 2 claws and 2 guides.

    3. A01CE9QE01

      Disengage the 2 claws and disconnect the DLC3.

    4. Disengage the clamp.

    5. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.

  3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)


    1. A01CC18

      Disengage the 3 claws and disconnect the hood lock control cable assembly.

    2. A01CC11

      Disengage the 3 claws and disconnect the fuel lid lock control cable assembly.

    3. A01CCKN

      Remove the 3 screws <B>.

    4. Disengage the 14 claws and the 3 guides, and remove the lower instrument panel finish panel as shown in the illustration.

      A01CCUJ

      Note


      • Make sure to follow the order shown in the illustration to avoid damage to the lower instrument panel finish panel.

      • While supporting the knee airbag, remove the lower instrument panel finish panel.

  4. REMOVE TURN SIGNAL FLASHER ASSEMBLY (for RHD)


    1. Disconnect the connector.

    2. A01CDU5

      Disengage the claw and remove the turn signal flasher assembly.

  5. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)

    Click here

  6. REMOVE TURN SIGNAL FLASHER ASSEMBLY (for LHD)


    1. A01CAUB

      Disengage the clamp and remove the turn signal flasher assembly.

    2. Disconnect the connector.