REAR COMBINATION LIGHT ASSEMBLY (for VELLFIRE) ON-VEHICLE INSPECTION


  1. INSPECT REAR COMBINATION LIGHT ASSEMBLY


    1. A01CEQZE10

      Disconnect the connector from the rear combination light assembly.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      LH Side
      Tester Connection Condition Specified Condition
      N6-3 - N6-4 Light control switch off Below 1 V
      Light control switch in TAIL 11 to 14 V
      N6-1 - N6-4 Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      N6-2 - N6-4 Turn signal switch off Below 1 V
      Engine switch on (IG) and turn signal switch in LH position 11 to 14 V (60 to 120 times per minute)
      RH Side
      Tester Connection Condition Specified Condition
      M13-3 - M13-4 Light control switch off Below 1 V
      Light control switch in TAIL 11 to 14 V
      M13-1 - M13-4 Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      M13-2 - M13-4 Turn signal switch off Below 1 V
      Engine switch on (IG) and Turn signal switch in RH position 11 to 14 V (60 to 120 times per minute)

      If the result is not as specified, repair or replace the wire harness or connector.