Click here

RAIN SENSOR INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL RAIN SENSOR TAPE

    Note:

    The rain sensor tape can be reused, however, replace it with a new one if it is dirty or damaged.

    Tip:

    This step should be performed only when the rain sensor tape needs to be replaced.


    1. A01CAOLE01

      Remove the release sheet (yellow side) from new rain sensor tape and apply the tape to the position indicated in the illustration (the sensing part of the rain sensor) while pushing out air bubbles with your fingers.

    2. Remove the release sheet (white side) from the rain sensor tape.

      Note:

      • Check that the old rain sensor tape is not left on the windshield glass. If the tape is still on the windshield glass, remove it before installing the rain sensor.

      • Do not touch the sensor tape surface or the glass surface directly with your fingers.

      • Clean up dirt on the glass with a piece of cloth, etc.

      Dimension Specified Condition
      A 7.3 mm (0.287 in.)
      B 13.5 mm (0.531 in.)
  2. Click here

    INSTALL RAIN SENSOR


    1. A01CEIME03

      Connect the connector.

    2. Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.

    3. Push in the stopper.

      Note:

      • Do not touch the sensor tape surface or the glass surface directly with your fingers.

      • Clean up dirt on the glass with a piece of cloth, etc.

      • After installing the rain sensor, there should be no air bubbles between the windshield glass and the rain sensor tape.

  3. Click here

    INSTALL RAIN SENSOR COVER


    1. A01CFUFE03

      Engage the 2 claws.

    2. Install the rain sensor cover as shown in the illustration.