LIGHTING SYSTEM, Diagnostic DTC:B2416

DTC Code DTC Name
B2416 Height Control Sensor Malfunction

DESCRIPTION

The AFS ECU receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly LH.

DTC No. DTC Detection Condition Trouble Area
B2416
  • Malfunction in rear height control sensor sub-assembly LH

  • Open or short in rear height control sensor sub-assembly LH circuit


  • Rear height control sensor sub-assembly LH

  • Harness or connector

  • AFS ECU

WIRING DIAGRAM

A01CGAJE11

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC B2416 is not output.

    NG
    OK
  2. CHECK HARNESS AND CONNECTOR (AFS ECU - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH)


    1. A01CCZAE01

      Disconnect the A23 AFS ECU connector.

    2. Disconnect the N7 height control sensor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A23-18 (B) - N7-3 (SHB) Always Below 1 Ω
      A23-19 (SHRL) - N7-2 (SHRR) Always Below 1 Ω
      A23-21 (SGF) - N7-1 (SHG) Always Below 1 Ω
      A23-18 (B) - Body ground Always 10 kΩ or higher
      A23-19 (SHRL) - Body ground Always 10 kΩ or higher
      A23-21 (SGF) - Body ground Always 10 kΩ or higher

    NG
    OK
  3. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A01CECVE01

      Connect 3 dry cell batteries (1.5 V) in series.

    2. Remove the height control sensor.

    3. Connect a positive (+) lead from the battery to terminal 3(SHB) and a negative (-) lead from the battery to terminal 1 (SHG).

    4. Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

      Standard Voltage
      Tester Condition Condition Specified Condition
      2 (SHRR) - 1 (SHG) +45° (High) 4.05 V
      0° (Normal) 2.25 V
      -45° (Low) 0.45 V

    NG
    OK