REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. A01CD55

      Install the rear wiper motor assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
    2. A01CCGO

      Connect the connector.

    3. Engage the 3 clamps.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A01CBQUE01

      Apply MP grease to the entire surface of the wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A01CEGS

      Install the wiper motor grommet.

  3. INSTALL REAR NO. 1 SPOILER COVER


    1. A01CFMD

      Engage the 2 clips to install the rear No. 1 spoiler cover.

  4. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Stop the wiper motor at the automatic stop position.

    2. When reusing the rear wiper arm and blade assembly:


      1. A01CDESE01

        Clean the wiper arm serrations.

    3. When reusing the rear wiper motor assembly:


      1. A01CEZ0E01

        Clean the wiper pivot serrations with a wire brush.

    4. A01CE9XE01

      Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

      Standard Measurement
      Dimension Specified Condition
      a 16.0 mm (0.629 in.)
      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    5. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

  5. INSTALL BACK DOOR CENTER GARNISH


    1. A01CCZU

      Engage the 6 clips and 4 claws to install the back door center garnish.