BACK DOOR SUPPORT INSTALLATION


  1. INSTALL BACK DOOR STAY ASSEMBLY

    Note


    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • Do not apply any horizontal load to the door stay in order to prevent the rod from deforming.


    1. Clean the threaded surface on the vehicle body with a non-residue solvent.

    2. A01CBLRE03

      Apply adhesive to the threads of the 4 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
      Standard dimension
      A
      14.0 mm (0.551 in.)
    3. A01CALG

      Install the back door stay assembly with the 4 bolts.

      Torque:
      22 N*m  { 224 kgf*cm, 16 ft.*lbf }

      Note

      Install the back door stay assembly while supporting the back door by hand.

    4. Check that the back door stay assembly is engaged in the ball joint and that the back door stay assembly cannot be pulled out.