POWER SLIDE DOOR CONTROL SWITCH (for Instrument Panel Side) INSPECTION


  1. INSPECT NO. 1 POWER SLIDE DOOR CONTROL SWITCH


    1. A01CE5QE01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      G99-4 (CSW) - G99-1 (E) Pushed Below 1 Ω
      G99-4 (CSW) - G99-1 (E) OFF 10 kΩ or higher

    2. Apply battery voltage to the No. 1 power slide door control switch and check that the switch illuminates.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → G99-3

      Battery negative (-) → G99-2

      		 Illuminates

      If the result is not as specified, replace the bulb.