SLIDE DOOR LOCK RELEASE MOTOR REMOVAL


  1. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. Move the door inside handle knob to the lock position.

    2. A01CG64

      Using a T25 "TORX" socket wrench, remove the screw.

    3. Using a clip remover, disengage the 15 clips and 5 claws.

    4. Disconnect the connector and remove the rear door trim board sub-assembly.

  2. REMOVE SLIDE DOOR WINDOW GARNISH (w/o Navigation System for HDD)


    1. A01CDVI

      Disengage the 5 clips and remove the slide door window garnish.

  3. REMOVE SLIDE DOOR WINDOW GARNISH (w/ Navigation System for HDD)


    1. A01CCFR

      Disconnect the connector.

    2. Disengage the 5 clips and remove the slide door window garnish.

  4. REMOVE SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSEMBLY


    1. A01CFGL

      Disconnect each connector.

    2. Remove the 3 bolts.

    3. Disengage the guide.

    4. A01CD22

      Disconnect each cable and remove the slide door lock remote control sub-assembly from the rear door panel.

  5. REMOVE SLIDE DOOR LOCK RELEASE MOTOR ASSEMBLY


    1. A01CG36

      Disengage the clamp.

    2. Disconnect the connector.

    3. Remove the 3 screws and remove the slide door lock release motor assembly.