POWER SLIDE DOOR SYSTEM Slide Door Lock Release Motor RH Circuit

DESCRIPTION

The slide door lock release motor assembly RH unlocks the power slide door lock and unlock position switch when the power slide door is operated by the transmitter or power slide door control switch with the slide door closed.

WIRING DIAGRAM

A01CCCAE02

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT SLIDE DOOR LOCK RELEASE MOTOR ASSEMBLY RH


    1. A01CDSHE02

      Remove the slide door lock release motor assembly RH Click here.

    2. Apply battery voltage to the motor terminals and check the operation of the slide door lock release motor assembly RH.

      OK
      Tester Connection Condition Specified Condition
      K7-1 (SD+) - K7-2 (SD-) Battery voltage is applied to terminal 1 (SD+) Lock released
      Standard Stroke
      26.0 to 30.3 mm (1.02 to 1.19 in.)

    NG

    REPLACE SLIDE DOOR LOCK RELEASE MOTOR ASSEMBLY RH Click here

    OK

  2. CHECK NO. 1 REAR DOOR WIRE (LOCK RELEASE MOTOR RH - ECU RH)


    1. Disconnect the K5 power slide door ECU RH connector.

    2. Measure the resistance according to the value(s) in the table below.

      A01CDUVE02
      Standard Resistance
      Tester Connection Condition Specified Condition
      K7-1 (SD+) - K5-9 (RACT) Always Below 1 Ω
      K7-1 (SD+) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE NO. 1 REAR DOOR WIRE Click here

    OK

  3. CHECK NO. 1 REAR DOOR WIRE (LOCK RELEASE MOTOR RH - BODY GROUND)


    1. Disconnect the KM1 No. 1 rear door wire connector.

    2. Measure the resistance according to the value(s) in the table below.

      A01CCI7E01
      Standard Resistance
      Tester Connection Condition Specified Condition
      K7-2 (SD-) - KM1-4 (E) Always Below 1 Ω

    NG

    REPAIR OR REPLACE NO. 1 REAR DOOR WIRE Click here

    OK

  4. CHECK HARNESS AND CONNECTOR (BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      KM1-4 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here