SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (POWER SLIDE DOOR CONTROL SWITCH) (for Front Side)


    1. A01CD6TE04

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (OPN) - 7 (E) Front sliding roof switch is OPEN Below 1 Ω

      3 (OPN) - 7 (E)

      8 (CLS) - 7 (E)

      		 Front sliding roof switch is OFF 10 kΩ or higher
      8 (CLS) - 7 (E) Front sliding roof switch is CLOSE Below 1 Ω

      If the result is not as specified, the sliding roof switch (power slide door control switch) (for front side) may be malfunctioning.

    2. Check that the switch illuminates.


      1. Apply battery voltage to the sliding roof switch (power slide door control switch) (for front side) and check that the switch illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (ILL+)

        Battery negative (-) → 2 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the bulb.

  2. INSPECT SLIDING ROOF SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY) (for Rear Side)


    1. A01CENCE02

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (HPR-) - 12 (E) Rear sliding roof switch is CLOSE Below 1 Ω

      2 (HPR-) - 12 (E)

      3 (HPR+) - 12 (E)

      		 Rear sliding roof switch is OFF 10 kΩ or higher
      3 (HPR+) - 12 (E) Rear sliding roof switch is OPEN Below 1 Ω

      If the result is not as specified, the sliding roof switch (integration control and panel assembly) (for rear side) may be malfunctioning.