REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) INSTALLATION


  1. INSTALL REAR NO. 1 SEAT ASSEMBLY


    1. Place the rear No. 1 seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Temporary install the rear No. 1 seat assembly with the 4 bolts.

    3. A01CDB0E01

      Install the rear No. 1 seat assembly with the 4 bolts.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

    4. A01CCAR

      Engage the 4 claws to close the cover as shown in the illustration.

    5. A01CDGY

      Engage the 3 claws to close the cover as shown in the illustration.

    6. A01CEWA

      Engage the 3 claws to close the cover as shown in the illustration.

    7. A01CG2Z

      Engage the claw to close the cover as shown in the illustration.

  2. REAR SEAT SLIDE ADJUSTER LOCKS


    1. During the sliding operation of the rear No. 1 seat assembly, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster position.

  3. INSTALL REAR SEAT HEADREST ASSEMBLY