FRONT SEAT ASSEMBLY (for Manual Seat) INSTALLATION

INSTALL FRONT SEAT ASSEMBLY
1. Place the front seat assembly in the cabin.
  
  Note
  
  Be careful not to damage the vehicle body.
2. Connect each connector.
3. Temporarily install the front seat assembly with the 4 bolts.
4. Lift up the seat track adjusting handle and move the seat to the rearmost position.
5. Tighten the 2 bolts on the front side of the seat.
  
  Torque:
  
  39 N*m { 398 kgf*cm, 29 ft.*lbf }
  
  Tech Tips
  
  Tighten the bolts in the order indicated in the illustration.
6. Engage the 2 claws and the guide to close the cover.
7. Engage the 2 claws and the guide to close the cover.
8. Lift up the seat track adjusting handle and move the seat to the foremost position.
9. Tighten the 2 bolts on the rear side of the seat.
  
  Torque:
  
  39 N*m { 398 kgf*cm, 29 ft.*lbf }
  
  Tech Tips
  
  Tighten the bolts in the order indicated in the illustration.
INSPECT FOR FRONT SEAT SLIDE ADJUSTER LOCKS
1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the bolts securing the seat to adjust the adjuster position.
INSTALL FRONT SEAT HEADREST ASSEMBLY
INSTALL FRONT SEAT LEG COVER
1. Engage the 6 claws and the guide to install the front seat leg cover.
2. Install the floor carpet.
INSTALL NO. 3 FLOOR CARPET MOULDING
1. Engage the 2 clips and install the 2 No. 3 floor carpet mouldings.
INSTALL FRONT DOOR SCUFF PLATE ASSEMBLY
1. Engage the 3 guides, claw and 6 clips to install the door scuff plate assembly RH.
INSTALL COWL SIDE TRIM BOARD
1. Engage the 2 guides, claw and clip to install the cowl side trim board RH.
2. Install the clip(A).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SRS WARNING LIGHT

Click here.
INSPECT SEAT BELT WARNING SYSTEM

Click here.