LIN COMMUNICATION SYSTEM, Diagnostic DTC:B2324

DTC Code DTC Name
B2324 Rear Door LH ECU Communication Stop

DESCRIPTION

This DTC is output when LIN communication between the power window regulator motor assembly (for rear LH side) and main body ECU stops for more than 10 seconds.

DTC Code DTC Detection Condition Trouble Area
B2324 No communication between power window regulator motor assembly (for rear LH side) and main body ECU for more than 10 seconds.

  • Power window regulator motor assembly (for Rear LH side)

  • Main body ECU

  • Wire harness or connector

  • P/W RL fuse

WIRING DIAGRAM

A01CG8JE99

INSPECTION PROCEDURE

Note


  • When the power window regulator motor assembly (for rear LH side) is replaced or removed and reinstalled, it requires initialization Click here.

  • When using the intelligent tester to troubleshoot with the engine switch off:

    Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MOTOR - BATTERY AND BODY GROUND)


    1. Disconnect the L2 motor connector.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L2-1 (GND) - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      L2-2 (B) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE

    OK

  2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - POWER WINDOW REGULATOR MOTOR ASSEMBLY)


    1. Disconnect the G50 ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G50-10 (LIN2) - L2-9 (LIN) Always Below 1 Ω
      G50-10 (LIN2) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for REAR LH SIDE)


    1. Replace the power window regulator motor assembly (for rear LH side) Click here.


    NEXT

  4. CHECK DTC OUTPUT


    1. Clear the DTC Click here.

    2. Recheck for DTCs.

      OK
      DTC B2324 is not output.

    NG

    REPLACE MAIN BODY ECU Click here

    OK

    END (POWER WINDOW REGULATOR MOTOR ASSEMBLY IS DEFECTIVE)