TELEVISION CAMERA REMOVAL


  1. REMOVE BACK DOOR CENTER GARNISH


    1. A01CDVZ

      Using a moulding remover C, disengage the 6 clips and 4 claws, and remove the back door center garnish.

  2. REMOVE REAR WINDOW SIDE GARNISH LH (w/o Power Back Door)


    1. A01CCJHE01

      Disengage the 3 clips and 2 claws, and remove the rear window side garnish LH.

  3. REMOVE BACK DOOR NO. 2 SERVICE HOLE COVER (w/ Power Back Door)


    1. A01CAW9

      Disengage the 3 claws and remove the back door No. 2 service hole cover.

  4. REMOVE REAR WINDOW SIDE GARNISH LH (w/ Power Back Door)


    1. A01CEXNE01

      Disengage the 3 clips and 2 claws, and remove the rear window side garnish LH.

  5. REMOVE REAR WINDOW SIDE GARNISH RH


    1. A01CC6DE01

      Disengage the 3 clips and 2 claws, and remove the rear window side garnish RH.

  6. REMOVE BACK DOOR INSIDE HANDLE


    1. A01CF6X

      Using a moulding remover, disengage the 4 claws as shown in the illustration and remove the back door inside handle.

  7. REMOVE SWITCH BEZEL (w/ Power Back Door)


    1. A01CF0R

      Disengage the 6 claws and remove the switch bezel.

  8. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    1. A01CEQ2E01

      Using a clip remover, remove the 2 clips <A>.

    2. Disengage the 17 clips and remove the back door trim board assembly.

      Note

      w/ Power Back Door:

      To prevent the parts from being damaged, make sure that the back door trim board assembly does not get caught on the power back door closer switch assembly during removal.

  9. REMOVE REAR TELEVISION CAMERA ASSEMBLY


    1. A01CC7D

      Disconnect the connector.

    2. Remove the 2 screws.

    3. A01CBIK

      Disengage the 2 clamps and remove the rear television camera assembly.