QUARTER TRIM SPEAKER INSPECTION


  1. INSPECT REAR NO. 2 SPEAKER ASSEMBLY

    Tech Tips

    Remove interior parts so that the rear No. 2 speaker assembly can be seen.


    1. Check the speaker installation.

      OK
      The speaker is securely installed.

      If the result is not as specified, reinstall the rear No. 2 speaker assembly.

    2. Visually check the speaker.

      OK
      The cone paper of the speaker is not torn.

      If the result is not as specified, replace the rear No. 2 speaker assembly.

    3. A01CG11E59
      Text in Illustration
      *a

      Component without harness connected

      (Rear No. 2 Speaker Assembly)

      Speaker resistance check


      1. Disconnect the rear No. 2 speaker assembly connector.

      2. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Always 3.2 to 4.8 Ω

        If the result is not as specified, replace the rear No. 2 speaker assembly.