Click here

FRONT DOOR SPEAKER INSPECTION

Click here
Click here Click here
  1. Click here

    INSPECT FRONT NO. 1 SPEAKER ASSEMBLY

    Tip:

    Remove interior parts so that the front No. 1 speaker assembly can be seen.


    1. Check the speaker installation.

      OK
      The speaker is securely installed.

      If the result is not as specified, reinstall the front No. 1 speaker assembly.

    2. Visually check the speaker.

      OK
      The cone paper of the speaker is not torn.

      If the result is not as specified, replace the front No. 1 speaker assembly.

    3. A01CG11E59

      Speaker resistance check


      1. Disconnect the front No. 1 speaker assembly connector.

      2. Measure the resistance according to the value(s) in the table below.

        Standard Resistance (w/o Front Center Speaker)
        Tester Connection Condition Specified Condition
        1 - 2 Always 3.2 to 4.8 Ω
        Standard Resistance (w/ Front Center Speaker)
        Tester Connection Condition Specified Condition
        1 - 2 Always 4.8 to 7.2 Ω

        If the result is not as specified, replace the front No. 1 speaker assembly.

        Table 1. Text in Illustration
        *a

        Component without harness connected

        (Front No. 1 Speaker Assembly)