Click here

REAR SEAT ENTERTAINMENT SYSTEM (w/o Front Center Speaker) Television Display Power Source Circuit

Click here
Click here Click here
DTC Code DTC Name
  Television Display Power Source Circuit
Click here

DESCRIPTION

This is the power source circuit to operate the television display assembly.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY POWER SOURCE)


    1. Disconnect the S6 television display assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      S6-17 (GND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      S6-1 (+B) - S6-17 (GND) Always 11 to 14 V
      S6-2 (ACC) - S6-17 (GND) Engine switch on (ACC) 11 to 14 V

  2. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY, BODY GROUND)