DESCRIPTION
The television display assembly sends the sound signal to the radio receiver assembly through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly, television display assembly or speakers.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
Disconnect the radio receiver assembly and television display assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
INSPECT TELEVISION DISPLAY ASSEMBLY
| *a | Component with harness connected (Television Display Assembly) |
Reconnect the television display assembly connector.
Check the waveform according to the conditions shown in the table below.
| Result | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPLACE TELEVISION DISPLAY ASSEMBLY Click here |
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here