FRONT BRAKE FLEXIBLE HOSE REMOVAL

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure listed is for the LH side.


  1. REMOVE FRONT WHEEL

  2. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. REMOVE FRONT FLEXIBLE HOSE


    1. A01CC46

      While holding the front flexible hose with a wrench, separate the brake tube from the front flexible hose using a union nut wrench (10 mm).

      Note


      • Do not kink or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.

    2. Remove the clip and disconnect the front flexible hose from the bracket on the body

    3. Remove the bolt and separate the front flexible hose from the steering knuckle.

    4. Remove the bolt, speed sensor harness bracket and front flexible hose from the absorber bracket.

    5. A01CB8D

      Remove the union bolt, front flexible hose and gasket from the front disc brake cylinder assembly.

      Note

      If both left and right side hoses are disconnected at the same time, be sure to place identification marks indicating the position on each side.