REAR BRAKE DISASSEMBLY


  1. REMOVE CYLINDER BOOT


    1. A01CATJE01

      Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the rear disc brake cylinder assembly.

      Note

      Do not damage the inner surface or boot groove of the rear disc brake cylinder assembly.

  2. REMOVE REAR DISC BRAKE PISTON


    1. A01CB5WE01

      Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder to prevent any damage.

    2. Gradually apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.

      CAUTION:

      Do not place your fingers in front of the piston when using compressed air.

      Note

      Do not allow any brake fluid to spatter.

  3. REMOVE PISTON SEAL


    1. A01CFJ4E01

      Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the rear disc brake cylinder assembly.

      Note

      Do not damage the inner surface or piston seal groove of the cylinder.

  4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

  5. REMOVE REAR DISC BRAKE BLEEDER PLUG