TIRE AND WHEEL SYSTEM INSPECTION


  1. INSPECT TIRES


    1. Check the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure
      Tire Size

      Front

      kPa (kgf/cm2, psi)

      Rear

      kPa (kgf/cm2, psi)
      For diving under 160 km/h (100 mph) For driving at 160 km/h (100 mph) or over For diving under 160 km/h (100 mph) For driving at 160 km/h (100 mph) or over

      215/65R16 98H

      215/60R17 96H

      		 240 (2.4, 35) 300 (3.0, 44) 240 (2.4, 35) 300 (3.0, 44)
    2. A01CEXB

      Using a dial indicator, check the runout of the tires.

      Maximum tire runout
      1.4 mm (0.0551 in.)

  2. ROTATE TIRES


    1. A01CCXNE01

      Rotate the tires as shown in the illustration.

  3. INSPECT WHEEL BALANCE


    1. A01CG9JE02

      Check and adjust the off-the-car balance.

      Maximum imbalance after adjustment
      8.0 g (0.0176 lb.)

      Note


      • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

      • Do not touch the adhesive surface of the balance weight.

      • Adhere the sticking type balance weight to the flat surface (A) shown in the illustration.

        Width (A)
        25 mm (0.984 in.)

      • Push the balance weight securely with a finger to adhere it to the position.

      • Do not reuse the balance weight.

      Tech Tips


      • The inner side balance weight should be installed by clipping it to the rim.

      • If necessary, check and adjust the on-the-car balance.

  4. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. Inspect the front axle hub bearing looseness Click here.

  5. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. Inspect the rear axle hub bearing looseness Click here.

  6. INSPECT FRONT AXLE HUB RUNOUT


    1. Inspect the front axle hub runout Click here.

  7. INSPECT REAR AXLE HUB RUNOUT


    1. Inspect the rear axle hub runout Click here.