REAR AXLE HUB BOLT REPLACEMENT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR WHEEL

  2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    1. A01CDH9

      Remove the 2 bolts and separate rear disc brake caliper assembly from the backing plate.

      Note


      • Do not disconnect the rear flexible hose from the rear disc brake caliper assembly.

      • Use wire or an equivalent tool to keep the rear disc brake caliper assembly from hanging down by the rear flexible hose.

  3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG


    1. Remove the parking brake shoe adjusting hole plug from the rear disc.

  4. REMOVE REAR DISC


    1. A01CCF7E01

      Put matchmarks on the rear disc and axle hub.

    2. Release the parking brake.

    3. A01CG9U

      Turn the shoe adjuster to contract it until the disc turns freely, and then remove the rear disc.

  5. REMOVE REAR AXLE HUB BOLT


    1. A01CE6C

      Position the rear axle hub bolt to be removed as shown in the illustration.

    2. A01CEZXE01

      Temporarily install 2 nuts to the rear axle hub bolt as shown in the illustration.

      Recommended service nut
      Thread diameter: 12.0 mm (0.472 in.)
      Thread pitch: 1.5 mm (0.0591 in.)

      Note

      Install hub nuts to prevent damage to the hub bolts.

    3. Using SST and a brass bar or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.

      SST
      09628-10011

      Note

      Do not damage the threads of the rear axle hub bolts.

  6. INSTALL REAR AXLE HUB BOLT


    1. Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.

    2. A01CBD5E01

      Install a washer and nut to the new rear axle hub bolt as shown in the illustration.

      Recommended service nut
      Thread diameter: 12.0 mm (0.472 in.)
      Thread pitch: 1.5 mm (0.0591 in.)

      Tech Tips

      The thickness of the washer is preferably 5 mm (0.197 in.) or more.

    3. Using a brass bar or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

      Note


      • Install hub nuts to prevent damage to the hub bolts.

      • Do not damage the threads of the rear axle hub bolts.

    4. Remove the 3 nuts and washer from the 3 rear axle hub bolts.

  7. INSTALL REAR DISC


    1. A01CCF7E01

      Align the matchmarks and install the disc.

      Note

      When replacing the disc with a new one, select the installation position where the disc has the minimum runout.

  8. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

  9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


    1. A01CDH9

      Install the rear disc brake caliper assembly with the 2 bolts.

      Torque:
      88 N*m  { 900 kgf*cm, 65 ft.*lbf }

  10. ADJUST PARKING BRAKE

    Tech Tips

    Refer to the instructions for adjust parking brake Click here.

  11. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }