Click here

OIL PRESSURE SENSOR INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL OIL PRESSURE SENSOR


    1. Coat the O-ring of the oil pressure sensor with Toyota Genuine CVT Fluid FE.

    2. Using SST, install the oil pressure sensor.

      09326-22011
      without SST
      21 N*m 210 kgf*cm 15 ft.*lbf
      with SST
      16 N*m 159 kgf*cm 12 ft.*lbf
      Note:

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 155 mm (6.10 in.).

      • The "with SST" torque value is effective when SST is parallel to the torque wrench (Click here).

    3. Connect the oil pressure sensor connector.

  2. Click here

    INSTALL REAR ENGINE UNDER COVER LH

  3. Click here

    INSTALL FRONT WHEEL LH

    103 N*m 1050 kgf*cm 76 ft.*lbf
  4. Click here

    RESET MEMORY

    Tip:

    Perform Reset Memory (CVT initialization) when replacing the oil pressure sensor (Click here).