OIL PRESSURE SENSOR INSTALLATION


  1. INSTALL OIL PRESSURE SENSOR


    1. Coat the O-ring of the pressure sensor with Toyota Genuine CVT Fluid TC.

    2. Using SST, install the oil pressure sensor.

      SST
      09326-22011
      Torque:
      without SST
      21 N*m  { 210 kgf*cm, 15 ft.*lbf }
      with SST
      16 N*m  { 159 kgf*cm, 12 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 155 mm (6.10 in.).

      • The "with SST" torque value is effective when SST is parallel to the torque wrench Click here.

    3. Connect the oil pressure sensor connector.

  2. INSTALL REAR ENGINE UNDER COVER LH

  3. INSTALL FRONT WHEEL LH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. RESET MEMORY

    Tech Tips

    Perform Reset Memory (CVT initialization) when replacing the oil pressure sensor Click here.