REAR AXLE HUB REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR SPEED SENSOR WIRE


    1. A01CCITE01

      Using a screwdriver, disconnect the rear speed sensor wire from the rear speed sensor.

      Note

      Do not damage the rear speed sensor.

  3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    1. A01CDH9

      Remove the 2 bolts and separate rear disc brake caliper assembly from the backing plate.

      Note


      • Do not disconnect the rear flexible hose from the rear disc brake caliper assembly.

      • Use wire or an equivalent tool to keep the rear disc brake caliper assembly from hanging down by the rear flexible hose.

  4. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG


    1. Remove the parking brake shoe adjusting hole plug from the rear disc.

  5. REMOVE REAR DISC


    1. A01CCF7E01

      Put matchmarks on the rear disc and axle hub.

    2. Release the parking brake.

    3. A01CG9U

      Turn the shoe adjuster to contract it until the disc turns freely, and then remove the rear disc.

  6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. A01CETO

      Remove the 4 bolts and the rear axle hub and bearing assembly.

    2. A01CG0R

      Secure the parking brake assembly onto the rear axle beam assembly with the removed 4 bolts as shown in the illustration.

      Note

      Do not drop the parking brake assembly.