FRONT DIFFERENTIAL OIL SEAL REPLACEMENT


  1. REMOVE FRONT WHEELS

  2. REMOVE REAR ENGINE UNDER COVER LH

  3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID


    1. A01CEWO

      Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.

    2. A01CFJYE01
      Text in Illustration
      *1 No. 1 Transmission Oil Filler Tube

      Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the continuously variable transaxle assembly and drain the continuously variable transaxle fluid.

    3. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the continuously variable transaxle assembly.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }

    4. Temporarily install the gasket and overflow plug.

      Tech Tips

      Reuse the old gasket. The plug will be removed again to adjust the fluid level.

  4. REMOVE FRONT DRIVE SHAFT ASSEMBLY

    Click here.

  5. REMOVE CVT TYPE T OIL SEAL LH

    A01CE9TE02

    1. Using SST, tap out the oil seal from the transaxle case.

      SST
      09308-00010

      Note

      Do not damage the transaxle case.

  6. REMOVE CVT TYPE T OIL SEAL RH

    A01CC15E01

    1. Using SST, remove the oil seal from the transaxle housing.

      SST
      09308-00010

      Note

      Do not damage the transaxle housing.

  7. INSTALL CVT TYPE T OIL SEAL LH

    A01CEE7E02

    1. Using SST and a hammer, tap in a new oil seal to the transaxle case.

      SST
      09726-27012   ( 09726-02041 )
      09950-70010   ( 09951-07200 )
      Standard depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note

      Do not damage the oil seal lip.

    2. Coat the lip of the oil seal with MP grease.

  8. INSTALL CVT TYPE T OIL SEAL RH

    A01CFYXE01

    1. Using SST and a hammer, tap in a new oil seal to the transaxle housing.

      SST
      09387-00010
      09950-70010   ( 09951-07200 )
      Standard depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note

      Do not damage the oil seal lip.

    2. Coat the lip of the oil seal with MP grease.

  9. INSTALL FRONT DRIVE SHAFT ASSEMBLY

    Click here.

  10. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here.

  11. INSTALL REAR ENGINE UNDER COVER LH

  12. INSTALL FRONT WHEELS

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here.

  14. CHECK ABS SPEED SENSOR SIGNAL

    Check for the speed sensor signal Click here.