DIFFERENTIAL OIL SEAL REPLACEMENT


  1. DRAIN AUTOMATIC TRANSAXLE FLUID


    1. Remove the 5 clips and rear engine under cover LH.

    2. A01CEJG

      Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the automatic transaxle.

    3. A01CCOF

      Remove the refill plug and gasket from the automatic transaxle.

    4. A01CEFPE02

      Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle.

    5. Drain automatic transaxle fluid from the automatic transaxle.

    6. A01CEFPE02

      Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the automatic transaxle.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }
    7. A01CEJG

      Using a 6 mm socket hexagon wrench, install a new gasket and the overflow plug to the automatic transaxle.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }
    8. A01CCOF

      Install a new gasket and the refill plug to the automatic transaxle.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  2. REMOVE FRONT DRIVE SHAFT ASSEMBLY

    Tech Tips

    Click here

  3. REMOVE TRANSAXLE CASE OIL SEAL


    1. A01CG2DE03

      Using SST, tap out the transaxle case oil seal.

      SST
      09308-00010

  4. REMOVE FRONT TRANSAXLE CASE OIL SEAL


    1. A01CDLCE02

      Using SST, tap out the front transaxle case oil seal.

      SST
      09308-00010

  5. INSTALL FRONT TRANSAXLE CASE OIL SEAL


    1. A01CCQ2E01

      Using SST and a hammer, tap in a new front transaxle case oil seal.

      SST
      09316-60011
      09950-70010   ( 09951-07100 )
      Oil seal driven in depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note

      Check that the oil seal is installed in the correct direction.

    2. Coat the lip of the front transaxle case oil seal with MP grease.

  6. INSTALL TRANSAXLE CASE OIL SEAL


    1. A01CFX7E01

      Using SST and a hammer, tap in a new transaxle case oil seal.

      SST
      09316-60011   ( 09316-00011 )
      Oil seal driven in depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note

      Check that the oil seal is installed in the correct direction.

    2. Coat the lip of the transaxle case oil seal with MP grease.

  7. INSTALL FRONT DRIVE SHAFT ASSEMBLY

    Tech Tips

    Click here

  8. ADD AUTOMATIC TRANSAXLE FLUID

    Tech Tips

    Click here