ATF TEMPERATURE SENSOR INSTALLATION


  1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY


    1. A01CCT9E02

      Coat a new O-ring with ATF and install it to the ATF temperature sensor assembly.

    2. Coat the 4 bolts with ATF.

    3. A01CEVLE05

      Install the ATF temperature sensor assembly and clamp to the valve body with the 4 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }
      Bolt length
      Bolt A
      25 mm (0.984 in.)
      Bolt B
      85 mm (3.35 in.)

    4. Connect the connector.

  2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    1. A01CEF6E02

      Coat a new O-ring with ATF and install it to the oil strainer.

      Note

      Ensure that the O-ring is not twisted or pinched.

    2. A01CFOD

      Install the oil strainer to the valve body with the 2 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    1. A01CFCEE02

      Install the 2 magnets to the oil pan.

    2. Install a new gasket to the oil pan.

    3. Apply adhesive to the 18 bolts.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    4. A01CAQ7

      Install the oil pan to the automatic transaxle with the 18 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

      Note


      • In order to ensure proper sealing of the transmission oil pan bolts, apply adhesive to the bolts and install them within 10 minutes of adhesive application.

      • Completely remove any oil or grease from the contact surface of the transaxle case and oil pan sub-assembly with the gasket before installation.

  4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Tech Tips

    Click here