Click here

OIL PUMP REASSEMBLY

Click here
Click here Click here
  1. Click here

    INSTALL FRONT OIL PUMP OIL SEAL


    1. A01CERIE01

      Using SST, install a new oil seal to the pump.

      09350-32014 09351-32140
      Tip:

      The seal end should be flush with the outer edge of the oil pump.

    2. Coat the lip of the oil seal with petroleum jelly.

  2. Click here

    INSTALL FRONT OIL PUMP BODY O-RING


    1. A01CFWUE03

      Coat a new front oil pump body O-ring with ATF, and install it to the oil pump body.

  3. Click here

    INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A01CC5HE03

      Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.

      Table 1. Text in Illustration
      *a Mark
  4. Click here

    INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A01CAL1E26

      Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.

      Table 2. Text in Illustration
      *a Mark
  5. Click here

    INSTALL STATOR SHAFT ASSEMBLY


    1. A01CCVXE01

      Set the stator shaft assembly by aligning each bolt hole.

    2. Using a T30 ''TORX'' socket, install the 11 bolts.

      9.8 N*m 100 kgf*cm 87 in.*lbf
  6. Click here

    INSTALL CLUTCH DRUM OIL SEAL RING


    1. Install the 2 clutch drum oil seal rings.

      Note:

      Do not expand the ring ends excessively.

  7. Click here

    INSPECT OIL PUMP ASSEMBLY


    1. A01CG18E01

      Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.

      Note:

      Be careful not to damage the oil seal lip.