PARK / NEUTRAL POSITION SWITCH ADJUSTMENT


  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Remove the control shaft lever.

      Tech Tips

      See the steps from "Disconnect Cable From Negative Battery Terminal" through "Remove Park/neutral Position Switch Assembly" Click here.

    2. A01CDMJ

      Loosen the 2 bolts of the park/neutral position switch.

    3. A01CD1PE05

      Align the protrusions of the park/neutral position switch.

    4. A01CDMJ

      Hold the park/neutral position switch in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

    5. Install the control shaft lever.

      Tech Tips

      See the steps from "Install Park/neutral Position Switch Assembly" through "Connect Cable To Negative Battery Terminal" Click here.

    6. After the adjustment, perform the switch operation check Click here.