VALVE BODY ASSEMBLY INSTALLATION


  1. INSTALL MANUAL VALVE


    1. A01CCE1

      Coat the manual valve with ATF and install it to the valve body.

  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


    1. Coat the O-ring of the transmission wire with ATF.

    2. A01CD1TE01

      Confirm that the manual valve lever is positioned as shown in the illustration and install the valve body assembly to the transaxle case with the 11 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }
      Bolt length
      Bolt A
      25 mm (0.984 in.)
      Bolt B
      30 mm (1.18 in.)
      Bolt C
      35 mm (1.38 in.)
      Bolt D
      45 mm (1.77 in.)
      Bolt E
      55 mm (2.17 in.)

      Note


      • When installing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and transaxle case to interfere with each other.

      • Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.

      • First, temporarily tighten the bolts marked by *1 in the illustration because they are positioning bolts.

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    1. A01CEF6E02

      Coat a new O-ring with ATF and install it to the oil strainer.

      Note

      Ensure that the O-ring is not twisted or pinched.

    2. A01CFOD

      Install the oil strainer to the valve body with the 2 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    1. A01CFCEE02

      Install the 2 magnets to the oil pan.

    2. Install a new gasket to the oil pan.

    3. Apply adhesive to the 18 bolts.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    4. A01CAQ7

      Install the oil pan to the automatic transaxle with the 18 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

      Note


      • In order to ensure proper sealing of the transmission oil pan bolts, apply adhesive to the bolts and install them within 10 minutes of adhesive application.

      • Completely remove any oil or grease from the contact surface of the transaxle case and oil pan sub-assembly with the gasket before installation.

  5. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Tech Tips

    Click here