INSTALL MANUAL VALVE
Install the manual valve to the transmission valve body assembly.
INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Install the spring and check ball body.
Align the groove of the manual valve with the pin of the lever.
Coat the 17 bolts with ATF.
Install the transmission valve body assembly with the 17 bolts.
| 11 N*m | 112 kgf*cm | 8 ft.*lbf |
Push the valve body against the accumulator piston spring and the check ball body to install it.
Tighten the bolts marked by * in the illustration first temporarily because they are positioning bolts.
Each bolt length is indicated below.
| Bolt length |
|---|
| 25 mm (0.984 in.) for Bolt A |
| 41 mm (1.614 in.) for Bolt B |
| 45 mm (1.771 in.) for Bolt C |
Coat the O-ring with ATF.
Install the ATF temperature sensor with the lock plate and bolt.
| *1 | Lock Plate |
| *2 | O-ring |
| 6.6 N*m | 67 kgf*cm | 58 in.*lbf |
Connect the 5 shift solenoid valve connectors.
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
Coat a new O-ring with ATF.
Install the O-ring to the valve body oil strainer assembly.
Install the valve body oil strainer assembly with the 3 bolts.
| 11 N*m | 112 kgf*cm | 8 ft.*lbf |
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
Install the 3 magnets in the automatic transaxle oil pan sub-assembly.
| *1 | Magnet |
Install a new gasket and the automatic transaxle oil pan sub-assembly with the 18 bolts.
| 7.6 N*m | 77 kgf*cm | 67 in.*lbf |
INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH
Perform the same procedure as for the RH side.
INSTALL REAR ENGINE UNDER COVER LH
INSTALL NO. 1 ENGINE UNDER COVER
ADD AUTOMATIC TRANSAXLE FLUID
| Fluid type |
|---|
| Toyota Genuine ATF WS |
INSPECT TRANSAXLE FLUID LEVEL