AUTOMATIC TRANSAXLE SYSTEM INITIALIZATION


  1. RESET MEMORY

    Note


    • Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

    • RESET MEMORY can be performed only with the Intelligent tester.

    Tech Tips

    The ECM learns various conditions and controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can re-learn.

    Reset procedure is as follows.


    1. Turn the engine switch off.

    2. Connect the Intelligent tester to the DLC3.

    3. Turn the engine switch on (IG) and Intelligent tester on.

    4. Enter the following menu: Powertrain / Engine and ECT / Utility / Reset Memory. Then, press "Next".

      CAUTION:

      After performing RESET MEMORY, be sure to perform the ROAD TEST Click here described earlier.

      Tech Tips

      The ECM learns when the ROAD TEST is performed.