ENGINE SWITCH INSPECTION


  1. INSPECT ENGINE SWITCH

    A01CBNZE06

    1. Measure the resistance of the switch.

      Standard resistance
      Tester Connection Switch Position Specified Condition
      7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
      2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher
      7 (SS1) - 5 (GND) Pushed 15 Ω
      2 (SS2) - 5 (GND) Pushed 15 Ω

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

      Tech Tips


      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

      • If the voltage is too low, the indicator light will not illuminate.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 11 (SWIL)

      Battery negative (-) → Terminal 4 (COM) or 5 (GND)

      		 Illuminates

      Battery positive (+) → Terminal 12 (INDS)

      Battery negative (-) → Terminal 4 (COM) or 5 (GND)

      		 Illuminates

      Battery positive (+) → Terminal 13 (INDW)

      Battery negative (-) → Terminal 4 (COM) or 5 (GND)

      		 Illuminates
      A01CCX1E66

      If the result is not as specified, replace the engine switch.