OIL PRESSURE SWITCH INSTALLATION


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01CDPIE04

      Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. A01CAVO

      Install the wire harness bracket with the bolt.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

    4. Install the wire harness to the wire harness bracket.

    5. Connect the oil pressure switch connector.

  2. ADD ENGINE OIL


    1. A01CC54

      Add clean engine oil and install the oil filler cap.

      Note

      Do not allow engine oil adhere to the moving parts of the belt tensioner, as this may cause malfunctions.

      If engine oil is on the location indicated by the arrow, replace the belt tensioner.

      Standard Oil Grade
      Oil Grade Oil Viscosity (SAE)

      • API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil

      • 0W-20

      • 5W-20

      • 5W-30

      • 10W-30
      API grade SL, SM or SN multigrade engine oil

      • 15W-40

      • 20W-50
      Standard Capacity
      Item Standard Condition
      Drain and refill with oil filter change 6.1 liters (6.4 US qts, 5.4 lmp. qts)
      Drain and refill without oil filter change 5.7 liters (6.0 US qts, 5.0 lmp. qts)
      Dry fill 6.8 liters (7.2 US qts, 6.0 lmp. qts)

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Check for engine oil leaks from the connected parts of the oil filter cap and oil filter drain plug.

  4. INSTALL NO. 1 ENGINE UNDER COVER