PURGE VALVE REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01CCP4

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY


    1. A01CCUFE01

      Disconnect the No. 1 vacuum switching valve assembly connector.

    2. Disconnect the wire harness clamp.

    3. Disconnect the 2 fuel vapor feed hoses from the No. 1 vacuum switching valve assembly.

    4. A01CBRE

      Remove the bolt and No. 1 vacuum switching valve assembly.