CANISTER REMOVAL


  1. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE


    1. Remove the fuel suction tube assembly with pump and gauge Click here.

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A01CDDA

      Disconnect the harness clamp and remove the 2 harness protectors from the wire harness.

      Note

      Do not damage the wire harness.

    2. A01CG5J

      Disconnect the connector of the fuel sender gauge assembly.

    3. A01CBLVE01

      Disconnect the wire harness from the 4 harness clamps.

      Note

      Do not damage the wire harness.

    4. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.

  3. REMOVE NO. 1 FUEL SUCTION SUPPORT


    1. A01CC0N

      Disconnect the wire harness connector.

    2. A01CBSL

      Separate the wire harness.

    3. A01CC5E

      Detach the 2 claws and separate the No. 1 fuel suction support.

      Note

      Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube Click here.

    4. A01CG85

      Using a screwdriver, remove the jet pump.

      Tech Tips

      Tape the screwdriver tip before use.

    5. A01CAPGE04

      Remove the O-ring from the jet pump.

    6. A01CGFI

      Using a screwdriver, detach the 2 claws and remove the No. 1 fuel suction support.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE FUEL PUMP


    1. A01CFCX

      Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.

      Note


      • Do not damage the fuel suction filter and fuel filter.

      • Do not remove the fuel suction filter from the fuel pump.

      • Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube Click here.

      Tech Tips

      If the fuel filter assembly is to be replaced, replace the fuel suction plate sub-assembly.

    2. A01CCUP

      Disconnect the fuel pump connector.

    3. A01CCJ0E02

      Remove the O-ring and spacer from the fuel pump.

      Note

      Be careful not to damage the sealing surface.

      Tech Tips

      If the O-ring still remains in the fuel filter, remove it using a wire tip (φ1 mm) that is formed as shown in the illustration.

  5. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    1. A01CDDJ

      Remove the pressure regulator from the fuel filter.

    2. Remove the 2 O-rings.