FUEL PRESSURE REGULATOR

Click here
INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
1. Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel pressure regulator.
2. Install the fuel pressure regulator to the fuel filter.

INSTALL FUEL PUMP

Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.

Table 1. Text in Illustration
*1	O-ring
*2	Fuel Pump Spacer

Connect the pump harness connector.
Engage the 5 claws to install the fuel pump.
Note:
- Make sure that the O-ring is not cut or pinched during the installation.
- Engage the claws securely.

Click here
INSTALL NO. 1 FUEL SUCTION SUPPORT
1. Engage the 2 claws to install the No. 1 fuel suction support.
2. Apply gasoline to a new O-ring and install it to the jet pump.
3. Install the jet pump while aligning it with the installation position of the sub-tank.
  
  Note:
  Make sure that the O-ring is not cut or pinched during the installation.
4. Engage the 2 claws to install the No. 1 fuel suction support.
5. Install the wire harness.
6. Connect the wire harness connector.
Click here
INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Install the fuel sender gauge assembly by sliding the sender gauge downward.
2. Connect the wire harness to the 4 harness clamps.
  
  Note:
  Do not damage the wire harness.
3. Connect the connector of the fuel sender gauge assembly.
4. Install the 2 harness protectors and connect the harness clamp.
  
  Note:
  Do not damage the wire harness.
Click here
INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

Tip:
(Click here).

FUEL PRESSURE REGULATOR INSTALLATION