REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL ENGINE REAR OIL SEAL


    1. A01CFH9E01

      Apply MP grease to a new engine rear oil seal lip.

    2. Using SST and a hammer, tap in the engine rear oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Oil seal tap in depth
      -0.5 to 0.5 mm (-0.0196 to 0.0196 in.)

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01CAM5E01

      Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. A01CDPS

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive spacer with the pin hole of the crankshaft.

    4. A01CEPYE01

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

    5. A01CDZZE05

      Apply adhesive to 2 or 3 threads of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01CDNYE01

      In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      83 N*m  { 847 kgf*cm, 61 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Tech Tips

    See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" Click here.