FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. A01CDFFE02

      Apply MP grease to a new timing chain case oil seal lip.

    2. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010
      09506-35010
      Oil seal tap in depth
      0 to 1.0 mm (0 to 0.0393 in.)

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the timing chain case oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. A01CBG4

      Align the pulley set key with the key groove of the pulley, and slide on the pulley.

    2. A01CDROE02

      Using SST, install the pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      250 N*m  { 2550 kgf*cm, 184 ft.*lbf }

  3. INSTALL V-RIBBED BELT


    1. A01CD3WE01

      Install the V-ribbed belt.

    2. If it is difficult to install the V-ribbed belt, perform the following procedure:


      1. Put the V-ribbed belt on every pulley except the tensioner pulley as shown in the illustration.

      2. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner counterclockwise, and put the V-ribbed belt on the tensioner pulley.

        Note


        • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and idler pulley.

        • Check that the V-ribbed belt is properly set to each pulley.

    3. A01CEBW

      Turn the V-ribbed belt tensioner counterclockwise and remove a 5 mm bi-hexagon wrench.

    4. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01CAQT

      Install the front suspension member reinforcement RH with the 4 bolts.

      Torque:
      96 N*m  { 979 kgf*cm, 71 ft.*lbf }

  5. INSTALL REAR ENGINE UNDER COVER RH

  6. INSTALL NO. 1 ENGINE UNDER COVER

  7. INSTALL ENGINE UNDER COVER

  8. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }