DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A01CD3WE01

      Install the V-ribbed belt.

    2. If it is difficult to install the V-ribbed belt, perform the following procedure:


      1. Put the V-ribbed belt on every pulley except the tensioner pulley as shown in the illustration.

      2. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner counterclockwise, and put the V-ribbed belt on the tensioner pulley.

        Note


        • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and idler pulley.

        • Check that the V-ribbed belt is properly set to each pulley.

    3. A01CEBW

      Turn the V-ribbed belt tensioner counterclockwise and remove a 5 mm bi-hexagon wrench.

    4. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  2. INSTALL REAR ENGINE UNDER COVER RH

  3. INSTALL NO. 1 ENGINE UNDER COVER

  4. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }