REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. Apply MP grease to the lip of a new rear crankshaft oil seal.

    2. A01CAOUE02

      Using SST and a hammer, tap in the rear crankshaft oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01CCOPE02

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    2. A01CDPS

      Install the front spacer.

      Tech Tips

      Align the pin of the front spacer with the pin hole of the crankshaft.

    3. A01CD8VE01
      Text in Illustration
      *1 Drive Plate And Ring Gear Sub-Assembly
      *2 Rear Spacer
      A01CFEA Transaxle

      Install the drive plate and ring gear sub-assembly and rear spacer onto the crankshaft.

    4. Clean the 8 bolts and 8 bolt holes.

    5. A01CBLRE13
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01CFYUE02

      In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)

    Click here

  4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

    Click here