Click here

FRONT CRANKSHAFT OIL SEAL REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE FRONT WHEEL RH

  2. Click here

    REMOVE ENGINE UNDER COVER

  3. Click here

    REMOVE NO. 1 ENGINE UNDER COVER

  4. Click here

    REMOVE REAR ENGINE UNDER COVER RH

  5. Click here

    REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01CAQT

      Remove the 4 bolts and front suspension member reinforcement RH.

  6. Click here

    REMOVE RADIATOR COVER SUB-ASSEMBLY


    1. A01CDEV

      Using a clip remover, remove the 4 clips and radiator cover sub-assembly.

  7. Click here

    SEPARATE RADIATOR RESERVE TANK ASSEMBLY


    1. A01CERE

      Disconnect the wire clamp.

    2. A01CBJF

      Disconnect the No. 1 and No. 2 water by-pass hoses.

    3. Remove the bolt and radiator reserve tank assembly.

  8. Click here

    REMOVE RADIATOR RESERVE TANK BRACKET


    1. A01CF8W

      Remove the 2 bolts and radiator reserve tank bracket.

  9. Click here

    REMOVE V-RIBBED BELT


    1. A01CB9LE01

      Using SST, slowly turn the V-ribbed belt tensioner clockwise.

      09216-42010 09216-04010

    2. Remove the V-ribbed belt from each pulley and slowly return the tensioner.

      Note:

      • Make sure that SST and other tools are set to the tensioner securely.

      • When compressing the V-ribbed belt tensioner, slowly turn the tensioner.

      • Be careful not to pinch your fingers between the parts.

  10. Click here

    REMOVE CRANKSHAFT PULLEY


    1. A01CG29E02

      Using SST, hold the crankshaft pulley in place and loosen the pulley bolt.

      09213-54015 91651-60855
      09330-00021
    2. A01CG1RE01

      Using SST, remove the crankshaft pulley.

      09950-50013 09951-05010 09952-05010 09953-05020 09954-05021
      09950-40011 09957-04010
      Tip:

      If necessary, remove the pulley and pulley bolt using SST.

  11. Click here

    REMOVE FRONT CRANKSHAFT OIL SEAL


    1. A01CE3LE06

      Using a knife, cut off the lip of the oil seal.

      Table 1. Text in Illustration
      *1 Cut Position

    2. Using a screwdriver, pry out the oil seal.

      Note:

      Do not damage the surfaces of the oil seal press fit hole and crankshaft.

      Tip:

      Tape the screwdriver tip before use.