ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER

  2. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the reserve tank cap or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. A01CD8ME01
      Text in Illustration
      *1 No. 1 Engine Under Cover
      *a Hose

      Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.

    2. Loosen the radiator drain cock plug.

    3. Remove the reserve tank cap. Then drain the engine coolant.

      A01CF67E01
      Text in Illustration
      *1 Radiator Reserve Tank *2 Reserve Tank Cap
      *3 Radiator Drain Cock Plug - -

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

    4. Disconnect a hose with an inside diameter of 9 mm (0.354 in.) from the radiator drain cock.

  3. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    1. See the steps from "Remove windshield wiper arm cover" through "Remove windshield wiper motor and link assembly" Click here.

  4. REMOVE BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET


    1. A01CBAK

      Remove the 2 nuts and separate the brake master cylinder reservoir with bracket from the outer cowl top panel.

  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. A01CED5

      Apply protective tape as shown in the illustration.

      Text in Illustration
      A01CC81 Protective Tape
    2. A01CCFB

      Disconnect the 2 clamps from the outer cowl top panel.

    3. Remove the 8 bolts.

    4. A01CDT7

      Remove the outer cowl top panel as shown in the illustration.

  6. REMOVE AIR CLEANER CAP WITH HOSE


    1. A01CEOK

      Disconnect the No. 1 vacuum switching valve connector and wire harness clamp.

    2. Disconnect the fuel vapor feed hose from the No. 1 vacuum switching valve assembly.

    3. A01CCLR

      Disconnect the purge line hose from the No. 1 vacuum switching valve assembly and air cleaner hose.

    4. A01CFO3

      Disconnect the ventilation hose.

    5. A01CD15

      Disconnect the mass air flow meter connector.

    6. Disconnect the 2 wire harness clamps.

    7. A01CBRKE01
      Text in Illustration
      *1 No. 1 Air Cleaner Hose Clamp

      Lock the No. 1 air cleaner hose clamp as shown in the illustration, and disconnect the No. 1 air cleaner hose from the throttle body.

    8. A01CDPJ

      Disconnect the 2 clamps and remove the air cleaner cap with hose.

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01CFQU

      Disconnect the engine coolant temperature sensor connector.

    2. A01CCZRE01
      Text in Illustration
      *1 Gasket

      Remove the engine coolant temperature sensor and gasket.