CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. A01CBRGE12
      Text in Illustration
      *1 O-ring

      Apply a light coat of engine oil to the O-ring of the sensor.

    2. A01CDM4

      Install the camshaft position sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    3. Connect the camshaft position sensor connector.

  2. INSTALL AIR CLEANER CAP WITH HOSE


    1. A01CDPJ

      Install the air cleaner cap sub-assembly with hose and lock the 2 clamps.

    2. A01CEYSE01
      Text in Illustration
      *1 No. 1 air cleaner hose clamp
      *2 Groove
      *3 Tab
      *4 95°

      Connect the No. 1 air cleaner hose to the throttle body and release the lock of the No. 1 air cleaner hose clamp.

      Note


      • Align the groove of the air cleaner hose with the tab of the throttle body and install the hose.

      • Make sure that the tab of the No. 1 air cleaner hose clamp stays within the range shown by *4

    3. A01CD15

      Connect the 2 wire harness clamps and the mass air flow meter connector.

    4. A01CFO3

      Connect the ventilation hose.

    5. A01CCLR

      Connect the purge line hose to the No. 1 vacuum switching valve assembly and air cleaner hose.

    6. A01CEOK

      Connect the fuel vapor feed hose to the No. 1 vacuum switching valve assembly.

    7. Connect the wire harness clamp and No. 1 vacuum switching valve connector.

  3. INSPECT FOR ENGINE OIL LEAK

  4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. A01CCFB

      Install the outer cowl top panel with the 8 bolts.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

    2. Connect the 2 clamps to the outer cowl top panel.

    3. Remove the protective tape.

  5. INSTALL BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET


    1. A01CBAK

      Install the brake master cylinder reservoir with bracket to the outer cowl top panel with the 2 nuts.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

  6. INSTALL WINDSHIELD WIPER MOTOR AND LINK


    1. See the steps from "Install windshield wiper motor and link assembly" through "Install windshield wiper arm cover" Click here.