CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    1. See the steps from "Remove windshield wiper arm cover" through "Remove windshield wiper motor and link assembly" Click here.

  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET


    1. A01CBAK

      Remove the 2 nuts and separate the brake master cylinder reservoir with bracket from the outer cowl top panel.

  3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. A01CED5

      Apply protective tape as shown in the illustration.

      Text in Illustration
      A01CC81 Protective Tape
    2. A01CCFB

      Disconnect the 2 clamps from the outer cowl top panel.

    3. Remove the 8 bolts.

    4. A01CDT7

      Remove the outer cowl top panel as shown in the illustration.

  4. REMOVE AIR CLEANER CAP WITH HOSE


    1. A01CEOK

      Disconnect the No. 1 vacuum switching valve connector and wire harness clamp.

    2. Disconnect the fuel vapor feed hose from the No. 1 vacuum switching valve assembly.

    3. A01CCLR

      Disconnect the purge line hose from the No. 1 vacuum switching valve assembly and air cleaner hose.

    4. A01CFO3

      Disconnect the ventilation hose.

    5. A01CD15

      Disconnect the mass air flow meter connector.

    6. Disconnect the 2 wire harness clamps.

    7. A01CBRKE01
      Text in Illustration
      *1 No. 1 Air Cleaner Hose Clamp

      Lock the No. 1 air cleaner hose clamp as shown in the illustration, and disconnect the No. 1 air cleaner hose from the throttle body.

    8. A01CDPJ

      Disconnect the 2 clamps and remove the air cleaner cap with hose.

  5. REMOVE CAMSHAFT POSITION SENSOR


    1. A01CDM4

      Disconnect the camshaft position sensor connector.

    2. Remove the bolt and the camshaft position sensor.